Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Plane Speeds Were Not Possible.....Only A Fiction
#7
Sam Kent Wrote:Maximum operating velocity of 360 knots??? That’s only 414 mph. Economical cruising speed is 461 kts, far above your figure of 360.
The maximum operating speed (Vmo) of any Boeing 767 is 360 knots indicated airspeed. That is the speed, at which the overspeed warning in the cockpit goes on. At ground level, indicated airspeed is equal to true airspeed.
At higher altitudes Vmo is Mach 0.86. At, say 35000 feet, Vmo is only 295 knots indicated airspeed, but because of less air density this translates to
a much higher true airspeed.
So Peter's quote was exactly correct.

If you need a reference, try the type certificate: http://rgl.faa.gov/Regulatory_and_Guidan...E/A1NM.pdf
The most relevant literature regarding what happened since September 11, 2001 is George Orwell's "1984".
Reply


Messages In This Thread
Plane Speeds Were Not Possible.....Only A Fiction - by Carsten Wiethoff - 19-08-2010, 07:50 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  UK plane crash kills members of bin Laden family, police say Drew Phipps 1 3,544 02-08-2015, 05:38 AM
Last Post: Peter Lemkin
  Reported Airspeed of Plane Into WTC Impossible - Must Have Been Drone or Lie! Peter Lemkin 0 2,609 17-02-2014, 09:25 AM
Last Post: Peter Lemkin
  The 9/11 Mystery Plane and the Vanishing of America Peter Lemkin 9 7,206 06-10-2012, 03:31 PM
Last Post: Peter Lemkin
  The plane crashes of 9/11 were fabrications . . . James H. Fetzer 37 13,020 08-04-2012, 08:46 AM
Last Post: Ed Jewett
  Pentagon Employee Says Plane Did Not Crash into Building Jack White 11 7,781 25-09-2011, 02:16 PM
Last Post: Bernice Moore
  EXCELLENT New Film From 911 Pilots For Truth!!!!! Blows Official Fiction Out of Skies! Peter Lemkin 8 6,205 19-08-2011, 03:15 AM
Last Post: Albert Doyle
  Full On: Plane / No Plane and other Anomalies Debate re: the Pentagon Attack Peter Lemkin 0 2,583 05-02-2011, 09:00 AM
Last Post: Peter Lemkin

Forum Jump:


Users browsing this thread: 1 Guest(s)